XHD7714 OPERATION
General Operation
Faceplate Removal
Power On/Off
Mode
Auxiliary Input
Steering Wheel
Input Interface
Volume
Mute
Preset EQ Curves
Display
Set the Clock
Reset
Press OPEN to fold down the front panel, then pull away from the bottom to remove. To
Remove trim ring and install two supplied #1 x 7/32” Phillips head screws through both of mounting frame into faceplate.
Press 
or any other button to turn the unit on. Press and hold 
to turn the unit off.
Press MODE to select between AM/FM, CD player, USB, auxiliary input, iPod and Bluetooth. Modes of operation are indicated in the display.
Note: CD, USB and iPod modes will not appear unless a CD, USB device or iPod are inserted.
Insert a 3.5mm connector in the front panel AUX port. Connect the other end of the 3.5mm connector to the headphone output of an audio device, MP3 player, etc. Press MODE to select AUX mode.
The steering wheel interface input located on the back of the head unit allows connection to the Pacific Accessory Corporation
To configure steering wheel controls, follow the instructions provided with the PAC
Adjust volume using volume knob
Press to silence the audio. “MUTE” will flash in the display. Press 
again to cancel.
Press and hold EQ for 3 seconds to enter EQ setup menu, then use the volume knob to select between POP, JAZZ, CLASSIC, BEAT, ROCK and FLAT (default) equalization curves. Any adjustment to the Bass or Treble settings automatically cancels the current EQ curve (if one is selected).
Press DISP to select between clock and different types of information, such as radio frequency, CD track or MP3/USB song information.
With the unit on, press and hold DISP until the clock begins to flash, then release. Press TUNE nnto adjust the hours and TUNE llto adjust the minutes. Press DISP momentarily to save the selected time.
Press to RESET the unit upon initial installation or if abnormal operation occurs. Reset button is located behind the faceplate.
6
