Caution
Use of batteries.
∙Do not use batteries not specified for this unit. Do not use new batteries mixed together with old ones. This may cause a fire, injury due to burst of battery, liquid leakage.
∙When inserting batteries in this unit, pay attention to the direction of the 
and 
polarity indications and insert the batteries correctly. If the polarities are confused, it may cause injury or damage near the unit due to burst batteries, liquid leakage, etc.
Caution when replacing the lamp.
∙When replacing the lamp, turn off the power of the projector and disconnect the power plug from the power outlet. Then wait for
45 minutes to allow the lamp cool:
Failure to do so could result in a burn.
∙ For disposal of used lamp, treat according to the instruction of community authorities.
∙ Since the lamp is made of glass, do not apply shock to it and do not scratch it.
∙ Also, do not use old lamp. This could also cause |
explosion of the lamp. |
ENGLISH
When you are not going to use
for a long time.
When you are not going use this unit for a long time because you are going on a trip, etc., be sure to pull out the power plug from the power outlet for safety. And also apply cover to the lens so that the lens is not damaged.
Pull out the power plug from the power outlet.
∙ If it is probable that the lamp has exploded |
(explosive sound is heard), disconnect the power |
plug from the power outlet and ask your dealer |
to replace lamp. The lamp is covered by front |
glass and |
the reflector and the inside of the projector may |
be damaged by scattered broken pieces of glass, |
and broken pieces could cause injury when |
being handled. |
Clean inside the unit at least once two years.
Ask your dealer to clean inside the unit at least once two years. If the unit is left
with too much dust inside as it is for
a long this without cleaning, it may cause a fire. Especially it is effective
to clean before the rainy season
starts. Consult your dealer for the cost of the cleaning the inside the unit.
[General cautions]
∙ When the lamp has been replaced, reset the |
accumulated operation time of the lamp. |
∙ Do not reset if the lamp has not been replaced. |
Front glass
Reflector
Lamp
Do not place this unit where it gets hot.
Be careful since if you place the unit outdoors, in a place exposed to direct sunlight or near a heating device, the cabinet and parts could be affected.
Volume.
Use at the proper volume level so that it does not bother persons in the neighborhood. Especially, since the sound is likely to carry well at the night even at a low volume, consider the neighborhood to a good living environment.
Cleaning the lens.
To clean the lens, use a
Cleaning the cabinet.
∙Since many plastic materials are used on the surface of the cabinet, if the surface is cleaned using benzene, thinner, etc., it may change in quality or the coating may be peeled off. Avoid using chemicals.
∙When a
∙Do not spray a volatile agent such as insecticide on the unit. Do not leave a rubber or vinyl object touching the cabinet for a long time. It may cause the cabinet to change in quality or the coating to peel off.
∙Clean the dirt from the cabinet and operation panel by dusting lightly with a soft cloth. If the dirt is conspicuous, wipe off with a cloth moistened with detergent diluted with water, then wipe off with a dry soft cloth.
Rest your eyes occasionally when
viewing for a long time.
7
