Optimizing RGB Picture Automatically | Turning off the Projector |
OFFON
Adjusting the Image Using Auto Adjust
Optimizing RGB image automatically
Press the Auto Adjust button to optimize an RGB image automatically.
[Poor picture]
AUTO ADJ.
[Normal picture]
Press the Auto Adjust button to
This adjustment may be necessary when you connect your computer for the first time.
NOTE:
•Some signals may not be displayed correctly or take time.
•The Auto Adjust function does not work for component and video signal.
•If the Auto Adjust operation cannot optimize the RGB signal, try to adjust Clock and Phase manually. See page
To turn off the projector:
First, press the POWER (ON/STAND BY) but- ton on the projector cabinet or the POWER OFF button on the remote control. The “Power Off / Are you sure?” message will appear.
Secondly, press the ENTER button or press the POWER (ON/STAND BY) or the POWER OFF button again.
The power indicator will glow orange. After the projector turns off, the cooling fans keep op- erating for 60 seconds
Lastly, turn off the Main Power switch. The power indicator will go out. Last unplug the power cable.
CAUTION
Do not unplug the power cable from the wall outlet or do not turn off the main power under any one of the following circum- stances. Doing so can cause damage to the projector:
•While the Hour Glass icon appears.
•While the cooling fans are running. (The cooling fans continue to work for 60 sec- onds after the projector is turned off).
POWER
VIDEO | AUTO ADJ. |
RGB | |
MENU |
| SELECT |
E | L |
N | E |
T | NC |
ER | CA |
| PJ |
PICTURE | ASPECT |
HELP | FREEZE |
| MAGNIFY |
| VOLUME |
Turning Up or Down Volume
Sound level from the speaker and the AUDIO OUT jack (Stereo mini) on the projector can be adjusted.
VOLUME
increase volume
decrease volume