Part Names of the Projector
Controls (See page
Monaural Speaker (1W)
Lamp Cover (See page | Zoom Lever |
| |
Lamp Cover Screw | Focus Ring |
| |
| Lens |
Ventilation (outlet) | Adjustable Tilt Foot Lever |
Heated air is exhausted from here | (See page |
Adjustable Tilt Foot Lever | Adjustable Tilt Foot |
(See page | |
(See page |
|
| Lens Cap |
Adjustable Tilt Foot (See page | Remote Sensor (See page |
Remote Sensor (See page
Ventilation (inlet) / Filter Cover (inlet)
)*
Main Power Switch
When you plug the supplied power cable into an active wall outlet and turn on the Main Power switch, the POWER indicator turns orange and the projector is in standby mode. (See page
AC Input
Connect the supplied power cable's two- pin plug here, and plug the other end into an active wall outlet. (See page
*This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.
Attaching the lens cap
To attach the lens cap to the bottom with the supplied string and rivet:
1.Thread the string through the hole on the lens cap and then tie a knot in the string.
2. Use the rivet to attach the string to the bottom of the projector.
Attaching the supplied carrying handle
You can carry the projector by attaching the supplied carrying handle securely to the projector.
To attach the supplied carrying handle, use the supplied flathead screw- driver and two screws.
CAUTION:
When carrying the projector by the carrying handle, make sure the two screws that attach the carrying handle to the projector cabinet are tight.
