Basic Operation
Turning off the Projector - Procedure
1.Press the power button on the projector or remote control. The power off confirmation message appears .
2.Press the power button again and the projector will enter cool-down mode. The lamp shuts off, the lamp indicator flashes red, and the fans continue to run for approximately two minutes. During the cool down sequence the projector will not respond to any control panel or remote control buttons.
Do not set the power switch to off or unplug the
CAUTION projector during the cool-down sequence. Not allowing the lamp to cool properly will greatly reduce the life of the lamp.
3.After the cool-down sequence is completed the fans will shut off and the lamp indicator will stop flashing. The projector is now in standby mode and can be turned back on with the remote control or control panel. If the projector will not be used for an extended period, set the power switch to off and disconnect the power cord.
