IB-PDV704-WU-E-123106
HELPLINE: 0845 300 7775
1.The battery is depleted, please recharge the battery or use
the AC adaptor or car adaptor, make sure the AC outlet has power.
2.The fuse in the car adaptor is blown. To change the fuse,
unscrew the tip, replace only with same 3A 250V fuse.
3.The POWER switch is at the OFF position, please slide it to ON.
Remedy
TROUBLE SHOOTING
Symptom
No power.
Battery is fully charged
but does not work.
The battery protective circuit may have shut down the battery
for safety. To reactivate the battery, charge it for a while.
1.The disc may be damaged or scratched.
2.This player cannot play a DVD disc other than region 2 standard.
3.The disc may be dirty and may require cleaning.
4.Ensure that the disc is installed with the label side up (facing you).
5.If your disc is rented, it may be scratched or damaged from a
previous renter. Return it or polish it.
6.Condensation may have formed on your disc. Wait about 1
hour to allow the player to dry out.
1.Ensure that the equipment is connected properly. Double
check all cables and AC power.
2.Ensure that the A/V cables you used are attached in the
package, other cables may not be suitable for this DVD player.
3.Select the proper video channel on your TV set, VIDEO 1, 2, 3, etc.
4.Check if the proper AV input is selected on your TV set video
inputs (some TV sets have 3 or 4 different inputs).
5.Make sure both the TV and DVD player are on.
•Play fails to start even
when PLAY is pressed.
•Play starts but then
stops immediately.
No picture on your
external TV’s screen.
1.Picture is distorted during rapid advance or rapid reverse. The
picture may be somewhat distorted occasionally, this is normal.
General
2.Did you connect your DVD player to your VCR? Please connect
the player directly to your TV and disconnect the VCR. This
player has Macrovision copy protection, this will distort
pictures when used with VCRs.
The picture is distorted.
Battery drains too fast
in stop mode.
The set continues to be on even in stop mode. If you plan on
leaving the disc stopped for a longer time, turn the set’s power
off to conserve battery power or use the AC adaptor.
Some lines appear on
the screen during the
startup of the vehicle.
Please turn the unit off and turn it on again after the vehicle is
running.
The picture seems
squeezed or stretched.
The LCD mode and TV type you are in may be wrong for this
movie, try changing the LCD and TV type setting for standard
or widescreen. See pages 21 & 22.
25
No image on the LCD
screen.
The player’s LCD may be turned off (as when you are using the
external TV).
1. Press the little button marked SCREEN OFF #13 on page 4.
2. Press the SCREEN ON/OFF button on the remote.
IB-PDV704-WU-E-123106.pmd 2/15/2007, 11:26 AM26