DXG Technology DXG 552 manual Setup Mode

Press the “Prev” button to enter to the PICTBRIDGE menu page. Then press the Flash/Set Button to enter the sub menu.

※When you enter the PICTBRIDGE menu page, the camera will flash an icon of a cable which indicates you must insert a USB/AV cable that is connected to a printer. Only when the camera is connected to a PICTBRIDGE enabled printer can you enter the print-setting interface and begin printing pictures.

※If there is an error message on the LCD during printing, please refer to the error-type-table in the appendix. (see Page 38)

4-4 Setup Mode

In this mode, you can complete some special settings. There are two menu pages in this mode: SYSTEM 1 and SYSTEM 2.

Setup Operation:

(1)First, turn on the power, and press and hold the MODE button to enter the mode-selection menu. Then use the “Prev” and “Next” buttons to select the

setup symbol

(). Press the Flash/Set Button to enter.

(2)By pressing the down “Next” button, and the highlight bar will move between different menu items. Press the Flash/Set Button again to enter a sub menu.

(3)Press the up “Prev” button to enter to enter the SYSTEM 2 menu page.

(4)When setting the date and time, use the play button tab between numbers. Press the Flash/Set Button to save the settings.

22