Dynasty Spas D-1000, D-2000, D-3000 owner manual Preset Filter Cycles

To p S i d e C o n t r o l I n s t r u c t i o n s

D - 2000 System

Initial Start-up

When your spa is first powered up, it will automatically heat and maintain 100 F until you change the set temperature.

Temperature Adjustment

Press the pad to display the temperature setting. The set temperature is flashed on the display. In a few seconds, the numbers will

stop flashing, and the display will show the actual water temperature.

Pressing the pad a second time will cause the set temperature to increase or decrease depending on what direction was last chosen. Each press will change the set temperature in the same direction. If the opposite direction is desired, release the pad and let the display revert to the actual water temperature again. Press the pad to display the temperature, and

again to make the temperature change in the desired direction.

Jets

Press the pad to activate the low speed of pump 1. Press the pad again for the high speed of pump 1 (and pump 2 if installed). Press the jets pad again to turn off the pump(s). The low-speed pump also runs when the heater is on (not on circulation pump systems) and during filter cycles. If automatically activated, the low-speed pump cannot be disabled from the front panel; however, the high-speed pump(s) may be started. The low- speed pump turns off after 2 hours, and the high-speed pump(s) turn

off after 20 minutes.

Blower (optional)

Press the pad to turn the blower on and off. The blower will automatically turn itself off after 20 minutes.

Light

Press the pad to turn the spa light on or off. The light will automat- ically turn off after 1 hour.

Preset Filter Cycles

Your spa will automatically filter itself twice each day. The first filter cycle begins

14