Dynasty Spas D-3000, D-2000, D-1000 owner manual System auxiliary panel optional

To p S i d e C o n t r o l I n s t r u c t i o n s

D - 3000 System

D - 3000 System auxiliary panel (optional)

Initial Start-up

When your spa is first powered up, it will automatically heat and maintain 100F until you change the set temperature.

Temperature Adjustment

The current temperature is constantly displayed on the LCD. Press either or pad once to display the set temperature. (The temperature is designated by a triangle in the upper left corner.) Each time either pad is pressed, the set temperature will increase or decrease depending upon which pad is pressed. After three seconds, the LED will automatically display the current spa temperature.

Jets 1

Press the JETS 1 pad to activate the low speed of pump 1. Press the pad again for the high speed of pump 1. Press the JETS 2 pad again to turn off the pump. The low-speed pump runs when a filter cycle is activated or when a freezing condition is detected. If automatically activated, the low- speed cannot be disabled from the front panel; however, the high-speed pump may be started. The low- speed of pump 1 turns off after 2 hours, and the high-speed pump turns off after 20 minutes.

Jets 2

Press the JETS 2 pad to activate the low speed of pump 2. Press the pad again for the high speed of pump 2. Press the JETS 2 pad again to turn off the pump. Both speeds of the pump turns off after 20 minutes.

16