Connecting

Connecting

Fig. 2 Binding posts at rear of cabinet.

Connecting the loudspeakers

1.Connect a two-pole (+/-) loudspeaker cable to the binding posts, located at rear of the cabinet (see Fig. 2). The high quality, gold plated binding posts can accommodate different connection systems:

–4-mm-plugs (“banana plugs”): The pins can be put directly into the binding post without any tightening necessary.

–Cable spades: Un-tighten the binding posts, insert the spade into the opening, and secure the spade by tightening the posts.

–Bare wires: Un-tighten the binding posts and place the cable into the binding posts. Tighten the posts.

Note:

•With every connection system, ensure that the contact is tight and has a proper contact area.

•Connectors with similar gold plating as the loudspeakers binding posts will typically offer the best results and remain corrosion-free.

•Please ensure that the positive and negative cables do not make contact with each other.

•Tighten the posts, and check the contact after a few days to make sure that it hasn’t loosened.

6

Dynaudio Evidence

Page 6
Image 6
Dynaudio Evidence owner manual Connecting the loudspeakers