Dynaudio SUB 250 Switching the subwoofer on/off POWER ON/OFF, Operation, Connecting loudspeakers

Operation

Front Out/ Pre Out

LFE/SUB Out

Connecting loudspeakers

In Home Cinema systems the bass management - meaning the distribution of the low frequencies to the subwoofer and the speakers - is handled by the settings of the processor/receiver. If your equipment does not provide bass management, or if you want to use the SUB 250 together with a common stereo, the low frequency adjustment of the connected speakers can be managed by the SUB 250. This not only improves the sound by matching subwoofer and speakers, but also by freeing the power amplifier and connected speakers from the effects of sound-compromising bass reproduction. Also refer to the further explanations in the chapter “Connecting the subwoofer” on page 7.

Connecting speakers

1.Connect the subwoofer with the processor/receiver as explained in “Connecting a single subwoofer” on page 8.

2.From the Subwoofer SAT Output connect a RCA cable to the Main In of the power amplifier you use for your speakers.

Note:

•Stereos do not have a LFE channel. In this case just connect the front outputs of the processor/receiver (Front Out/Pre Out) with the subwoofer.

•The signals connected to the SAT/SUB Input are provided at the SUB I/O - LFE/To Slave output for connecting another subwoofer. See page 8 to learn more about connecting multiple subwoofers.

Switching the subwoofer on/off (POWER ON/OFF)

Once you have ensured yourself that all necessary connections have been made, the subwoofer and the connected components can be switched on.

XSwitch the subwoofer ON with the main POWER switch on the rear panel. The status LED on the rear of the subwoofer will light up red.

Automatic mode

After switching on the SUB 250 is in Automatic mode:

•When a music signal is detected, the internal amplifier is activated automatically.

The status LED on the rear of the subwoofer will light up green.

As long as a music signal is available on the subwoofer’s input, it will remain switched on.

•After 15 to 20 minutes of not sensing any input music signal, the subwoofer will switch itself to Standby mode automatically.

The status LED on the rear of the subwoofer will light up red

Note:

XTo switch the subwoofer completely off, set the main POWER switch to the OFF position.

Dynaudio SUB 250 9