Dynaudio SUB 250 manual Grille, Unpacking the subwoofer, Check that the contents are complete

1

2

3

Before operation

Unpacking

To find the suitable position for the SUB 250 in your listening room, please read the chapter “Positioning the subwoofer” on page 12.

Unpacking the subwoofer

1.Unpack the subwoofer on a clean, even and soft area; floor carpeting is very suitable.

2.The packaging should be opened from the top. Remove all accessories that come packed with the subwoofer (such as AC power cord and grille). Do not remove the top part of the protective material.

3.With the protective material still in place but with accessories removed, carefully tilt the packaging on its side and tilt again to turn it upside-down. Ensure that no part of the top-cover is obstructing the opening at the top.

4.The outer packaging can now be lifted away from the subwoofer itself. Remove the protective material that now is on top. Through the polyethylene bag you can now see the underside of the subwoofer.

5.Open the plastic bag and remove such from around the base of the subwoofer.

6.Again, carefully tilt the subwoofer on its side and again to turn it onto its feet. Note that the top part of the protective material will now come off easily so ensure that the subwoofer doesn’t drop or slide away in the process.

Check that the contents are complete:

•Subwoofer: The factory-set power requirements (refer to label on rear of subwoofer) should correspond for the region where the subwoofer was purchased. Refer also to chapter “Important Safety Instructions” on page 2.

•Front baffle grille.

•AC mains lead. The supplied lead should be suitable for the region where the subwoofer was purchased.

•Owners Manual.

Grille

The subwoofer can be operated without the grille. However, it is recommended that the grille is mounted during normal use to help prevent accidental damage or dirt settling on the cone of the loudspeaker. With subwoofers, the influence of the grille on the sound is virtually negligible.

To remove the grille:

XGently pull the grille at all corners.

To fit the grille:

XLine up the studs with the corresponding front baffle holes.

XGently push the grille in at all corners.

Note:

•Be careful when mounting the grille not to touch the cone of the loudspeaker itself.

Dynaudio SUB 250 5