Using your TV

Connecting an analog audio device

To connect an analog audio device:

•Connect one end of an audio cable to the AUDIO IN L and R jacks on the audio device, then connect the other end of the cable to the AUDIO OUT jacks on the back of your TV.

AUDIO IN

L R

Analog audio device

AUDIO OUT jacks

Connecting a computer

Note: Make sure that the VGA cable has a ferrite core.

To connect a computer:

1Connect one end of a VGA cable to the VGA jack on the computer, then connect the other end of the cable to the PC-INjack on the back of your TV.

Computer

Ferrite core

Mini audio cable

VGA cable

PC-IN video jack

PC-IN AUDIO jack

2Connect one end of a mini-plug audio cable to the

AUDIO LINE OUT jack on the computer, then connect the other end of the cable to the PC-IN AUDIO jack on the back of your TV.

Using your TV

Turning your TV on or off

To turn your TV on or off:

•Press POWER.

Warning: When you press POWER to turn off your TV, your TV goes into Standby mode. It is still receiving electrical power. To completely disconnect power, unplug the power cord.

11

Setting up for the first time

The first time you turn on your TV, a quick setup program starts that lets you select a language for the on-screen menu, select the TV signal source, and scan for available channels.

To set up your TV for the first time:

1Make sure that your TV is connected to an antenna, cable TV, or satellite TV.

2Press POWER. You may have to wait a few seconds for your TV to initialize. After your TV turns on, the Initial Setup screen opens.

InitialI i i l Setup

 

 

 

 

 

 

 

 

Select the language for setup display.

 

 

English

 

 

Elija el idioma de ajuste.

 

 

 

Español

 

 

 

 

 

Français

 

Sélectionner langue écran config.

 

 

 

 

 

 

 

 

 

 

Select

ENTER Enter

MENU

 

 

Exit

 

 

 

 

 

 

 

3Press or to select English, Español, or Français, then press ENTER. The following screen opens.

InitialI i i l Setup

Make sure the antenna is connected to "ANT.IN" jack.

Air

Select the destination of "ANT.IN" jack.

 

Cable

 

 

 

Air

 

 

 

Cable

Or

 

 

 

ANT.IN

 

 

 

 

Select

ENTER Enter

BACK

MENU

Back

Exit

4Press or to select Air (antenna) or Cable (cable or satellite TV), then press ENTER. The following screen opens, and your TV starts scanning for channels. Your TV stores the channel information in the channel list.

InitialI i i l Setup

Now the system is scanning for channels,please wait.

5%

Analog channels

1ch

 

 

 

 

 

 

 

 

Digital channels

0ch

 

 

 

 

 

 

 

 

 

MENU

Exit

When the scan is complete, the lowest channel in the channel list is displayed.

Notes:

The initial setup program only runs once for Air or Cable. If you change the TV signal source, you need to re-scan for channels. For more information, see “Scanning for channels” on page 12.

If you press POWER or MENU while your TV is scanning for channels, scanning will stop.

Note: When your TV does not receive a signal and you do not press any buttons for 15 minutes, your TV goes into Standby mode.