Dynex DX-LTDVD20 Features, Accessories, Front, Outdoor antenna grounding, Note to CATV system installer, No, PLAY, STOP, NEXT, PREV, MENU, menu, block, system, volume, CH+/CH–

4

Outdoor antenna grounding

If an outside antenna or cable system is connected to your TV combo, make sure that the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA No. 70, provides information with respect to correct grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of the antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

An outside antenna system should not be located near overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, because contact with them can be fatal.

		7
		6
		5
		4
		3
	1	2
1	Electric service equipment
2	Power service grounding electrode
	system
3	Ground clamps
4	Grounding conductors
5	Antenna discharge unit
6	Grounding clamp
7	Antenna lead-in wire

Note to CATV system installer

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for correct grounding and in particular, specifies that the cable ground must be connected to the grounding system of the building as close to the point of cable entry as practical.

Features

Accessories

Make sure that the following accessories are provided in the packaging:•YPbPr cable•Power cord•Remote control and batteries

Features

Front

	8			9	CH
1							10
		OPEN/			CH
		CLOSE
					VOL
2							11
			PLA Y		VOL
3		ST OP			MENU		12
4	DISC IN				INPUT		13
5					POWER		14
		NEXT
6					PHONES
		PREV
					INPUT 2
					VIDEO
7						L
						R
					AUDIO
No.	Component				Description
1	OPEN/CLOSE				Press to eject the disc in
					the disc slot.
2	PLAY				Press to change to DVD
					mode and begin disc
					playback.
3	STOP				Press to stop disc
					playback.
4	Disc IN indicator				When Iit, indicates a DVD
					or CD is loaded into the
					disc slot.
5	NEXT				Press to skip to the next
					chapter or track.
6	PREV				Press to skip to the
					previous chapter or track.
7	Disc slot				Insert a DVD or CD to
					change to DVD mode and
					play the disc.
8	Power/Standby indicator				Lights when your
					TV combo is plugged into
					a power outlet. When
					your TV combo is on, the
					indicator is green. When
					your TV combo is in
					standby mode, the
					indicator is red.
9	IR sensor				Receives signals from the
					remote control. Do not
					block.
10	CH+/CH–				Press to change the
					channel.
11	Volume+/Volume–				Press to adjust the
					volume.
12	MENU				Press to open the TV
					menu.