Dynex DX-LTDVD20 Troubleshooting, Specifications, DVD player, Problem, Problem, Problem, Solution, Solution, Solution, Troubleshooting

24

Troubleshooting

TV

Problem	Solution
No picture or sound.	Check all cable connections.
	Make sure that your TV combo is
	turned on.
Picture is OK, but no	Check the volume level and mute
sound.	setting.
Sound is OK, but no color.	Check the color control and adjust
	it. Check the program's color
	features because it may be a black
	and white movie.
The picture has	Make sure that the antenna is
overlapped images.	installed correctly. If not, adjust
	the antenna toward the
	broadcasting station.
Picture has snow.	Check the antenna and its
	connection. If there are problems,
	correct them. If all connections are
	tight, the problem may be with a
	faulty antenna or cable. Check car
	traffic or neon signs that may
	disrupt the image.
Stripes on picture.	Check for interference from other
	electronic devices, such as radios
	and televisions, and keep
	magnetic or electronic devices
	away from your TV combo.
Bad stereo or SAP sound.	A long distance from the
	broadcasting station or
	interference from radio waves can
	generate bad sound reception. If
	so, change the mode to Mono.
Remote control does not	Remove obstacles between the
work.	remote control and the player.
	Point the remote control at your
	TV combo's IR sensor.
	Install fresh batteries.
Your TV combo displays a	Check the resolution and
black or blue screen.	frequency of your computer, and
	adjust it to the optimum
	resolution for this TV: 1280 × 768
	at 60Hz.
No Signal appears on the	Make sure that the cable is firmly
screen.	connected to the computer and
	TV.
Image is not clear.	Adjust the phase control.
Image is not centered.	Adjust the horizontal control.

DVD player

Problem	Solution
No sound	Make sure that your TV combo or
	amplifier is working correctly.
	Make sure that the amplifier is set
	to receive DVD signal output.
No image	Make sure that your TV combo is
	working correctly.
	Make sure the color system is set
	correctly.
Bad sound quality	Make sure that the audio output
	mode is set correctly.
	Make sure that the audio
	connection between your
	TV combo and amplifier (if used) is
	secure.

	Troubleshooting
Problem	Solution
Disc cannot be played	Make sure that the disc is inserted
	with the label facing forward.
	Clean the disc.
	Moisture has condensed in the
	player. Remove the disc and leave
	the player on for about an hour to
	dry out.
The player does not	Disconnect the power plug, then
operate normally	reconnect it.
Remote control does not	Remove obstacles between the
work	remote control and the player.
	Point the remote control at your
	TV combo's IR sensor.
	Install fresh batteries.

Specifications

LCD	Panel	20" wide TFT LCD
	Resolution	1366 × 768
	Viewing angle	80°/80°/80°/60°
	Contrast ratio	500:1
	Brightness (cd/m2)	500
Dimension	With stand	20.9 × 16.6 × 8.3 inches
		(534 × 422 × 210 mm)
	Without stand	20.9 × 14.5 × 3.5 inches
		(534 × 368 × 90 mm)
Weight		21.3 lbs. (9.8 kg)
TV	TV standard	NTSC
	Tuning system	Electronic tuning
		system
	Frequency range	VHF/UHF
	Stereo	NICAM
	CATV	125 channels
Power	Input	100-240V AC, 50/60 Hz
	Consumption (Max.)	75 W
Sound	Output	3 W + 3 W
Terminals	A/V in	Video, S-Video, Audio
		L/R
	Component	Y, Pb (Cb), Pr (Cr)
	PC in	D-SUB 15-pin RGB in
	HDMI	HDMI compliant (type A
		connector)
	Antenna in	F-type
DVD player	Signal System	NTSC
	Applicable disc	DVD: 12 cm
		CD: 12 cm