Dynex DX-R27TV Setting up the television, the, CCD, EXIT, MUTE, CH +, ZOOM, menu, SLEEP, VOL +, INPUT, AUDIO, TUNER, screen, RECALL, button, (down), Notes:, menu to, function

Setting up the television

No.	Button	Description
4	SLEEP	To set the television to turn off after
		a preset amount of time, press the
		SLEEP button. The clock counts up
		ten minutes each time the button is
		pressed in the order of 0, 10,
		20...100, 110, 120 minutes. After the
		sleep time is programmed, the
		display disappears then reappears
		momentarily every ten minutes to
		remind you the sleep timer
		function is operating. To confirm
		the sleep time setting, press the
		SLEEP button once and the
		remaining time is momentarily
		displayed. To cancel sleep time,
		press the SLEEP button repeatedly
		until the display turns to 0.
5	VOL + / -	Press the + button to increase the
		volume level. Press the - button to
		decrease the volume level. Use
		these buttons to select the desired
		setting during the menu screen
		operation.
6	MENU/ENTER	Press to display the menu screen
		function.
		Press to enter or select operations
		during operation of the menu
		screen.
7	EXIT	Press to remove the menu screen.
8	INPUT	Press this button to display the
		SOURCE SELECTION menu to
		select the video input source.
9	RECALL	Press this button to go back to the
		previously viewed channel. Press
		this button again to return to the
		channel you were watching.
10	MUTE	To turn off the sound, press this
		button once. The television is
		silenced and the symbol MUTE
		appears on the screen. The muting
		feature can be turned off by
		pressing the MUTE button again or
		one of the VOL + or - buttons.
11	CH + / -	Press the CH + (up) button to change
		to a higher numbered channel set
		into memory. Press the CH - (down)
		button to change to a lower
		numbered channel set into
		memory. Use to select the desired
		setting during menu operation.
12	ZOOM	Press this button to change the
		picture size.
13	AUDIO	Press this button to select the
		desired sound.
14	CCD	Press this button to display the
		CLOSED CAPTION menu.
15	TUNER	Press this button to select the
		analog/digital mode.

5

Setting up the television

Connecting your television to AC power

Use the AC polarized cord provided for operation on AC. Insert the AC plug into a standard 120V 60 Hz polarized AC outlet.

AC outlet

Wider hole and blade

Polarized AC plug (one blade is wider than the other.)

Notes:

Never connect the AC plug to other than the specified voltage (120V 60 Hz). Use the attached power cord only.

If the polarized AC cord does not fit into a non-polarized AC outlet, do not file or cut the blade. It is your responsibility to have an electrician replace the obsolete outlet.

If you cause a static discharge when touching the television and the television fails to work, unplug the television from the AC outlet, then plug it back in. The television should work normally.

Installing batteries in the remote control

Before using the remote control, you must install batteries. Use two AAA size batteries. The batteries may last about one year depending on how much the remote control is used. For best performance, we recommend the batteries should be replaced on a yearly basis, or when the remote operation becomes erratic. Do not mix old and new batteries or different types.

To install batteries in the remote control:1Open the battery compartment cover.2Install two AAA batteries.