14

STEP 6 - Option 2: Installing on a solid concrete or concrete

block wall

CAUTION:
To prevent property damage or personal injury, never drill into mortar between blocks.
Mount the wall plate directly onto the concrete surface.
1
Align the wall plate (A) at the height you determined in the previous step, make sure that it is level, then
use a pencil to mark the lag bolt hole locations (4). Remove the wall plate (A).
2
Drill pilot holes to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter masonry drill bit.
3
Insert the concrete wall anchors* into the pilot holes and use a hammer to make sure the anchors are
flush with the concrete surface.
4
Align the wall plate (A) with the anchors, insert the lag bolts (P) through the lag bolt washers (O), then
through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate.
CAUTION:
Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (P).
*Not included. Call Customer Service to have the Fischer UX10 x 60 concrete anchor kit shipped directly to
you.
DX-TVMLPTB03_14-0885_MAN_V1_ENG.fm Page 14 Thursday, August 21, 2014 8:10 AM