EAW SB730, KF730 owner manual Quick Release Pins, Hinge and Hinge Tube Holes

6.4.3Quick Release Pins

Each KF730 is supplied with six 1.5 inch Quick Release Pins. Four are used for attaching enclosures together or to the Fly-Bar. Two are used as locking pins for the rear Hinges. See “Locking Pins” Section 6.4.5. Each SB730 is supplied with four 1.5 inch Quick Release Pins used for attaching enclosures together or to the Fly-Bar.

6.4.4Hinge and Hinge Tube Holes

DANGER: Ensure each Quick Release Pin used in assembling an array is fully inserted and engaged into the Hinge Tubes and Hinge holes. Only use the 1.5 inch Quick Release Pins supplied or equal. Pins of different lengths or diameter will compromise the structural integrity of the rigging system and may result in damage to the equipment, injury, or death.

The Hinges and Hinge Tubes, located on four corners of each enclosure, have several holes for inserting the Quick Release Pins to attach enclosures together or to the Fly-Bar. The particular holes used will determine the splay angles between the loudspeaker aiming axes. The rear splays required for these splay angles and the Hinge and Hinge Tube Holes to use to achieve them are designated by the KF730 Wizard.

NOTE: Each SB730 Hinge Tube has only one hole for attaching the Hinge of another enclosure. As

there is no choice of holes, it is neither labeled nor listed in the chart.

KF730 to Fly-Bar 1

Rear Hinge Hole		Rear Hinge Tube Hole	Front Hinge Hole	Front Hinge Tube Hole
3		Upper	2	Upper
KF730 to KF730 2				Front Hinge Hole
Front Splay Angle		Rear Hinge Hole	Rear Hinge Tube Hole
1.5°		1	A	2
3.0°		2	B	2
6.0°		3	B	2
12.0°		4	B	2
18.0°		4	B	1
SB730 to Fly-Bar	1			Front Hinge Tube Hole
Rear Hinge Hole		Rear Hinge Tube Hole	Front Hinge Hole
1		Upper	1	Upper
SB730 to SB730 2
Front Splay Angle		Rear Hinge Hole	Front Hinge Hole
0°		2	2
KF730 to SB730 2
Front Splay Angle		Rear Hinge Hole	Front Hinge Hole
-7.2°		1	2
-3.0°		2	2
0.0°		3	2
6.0°		4	2
12.0°		4	1

NOTES: 1. This positions the top surface of the enclosure so it is parallel to the plane of the KF730 Fly-Bar. 2. The front splay angle is the between the aiming axes, not the top/bottom enclosure surfaces.

RD0169 (A) KF730 & SB730 OWNER’S MANUAL Page 17 of 28