6.8.5Stacking Additional Enclosures (Fly-Bar as the base)
CAUTION: When attaching Hinges to Hinge Tubes in step 5 for an SB730, position the SB730 so it lies flat on the SB730 below it. In step 5 for a KF730, use the correct holes as determined by the KF730 Wizard or by the
1.Lift an SB730 or KF730 from its pallet and turn it upside down, so the Hinges on the enclosure are on the bottom.
2.Lift the enclosure onto the stack mating the alignment pads and recesses between them.
3.Remove the four Quick Release Pins from the Hinges of the upper enclosure.
4.If they do not drop from gravity, slide the four Hinges on the upper enclosure down into the Hinge Tubes on the enclosure below it.
5.Attach each Hinge to the Hinge Tube by inserting a Quick Release Pin (removed in Step 9) through both.
6.For a KF730, use its handles to lift the rear of the enclosure as far as possible and insert a Quick Release Pin (removed in step 2) into each of the enclosure’s rear Hinge Tubes as a locking pin. See “Locking Pins” Section 6.4.5.
7.Repeat steps 1 to 6 for additional enclosures.
Page 24 of 28 RD0169 (A) KF730 & SB730 OWNER’S MANUAL
