8
Contents
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts.
___ 1 - | ProThatch Attachment | |
___ 1 - | Dethatcher / Gear Housing Assembly | |
___ 1 - | Lower Drive Shaft Assembly | |
___ 1 | - | Fender / Wheel Assembly |
___ 1 | - | |
___ 1 | - | Operators Manual |
___ 1 | - | Warranty Registration Card |
ProThatch Attachment
Operator's Manual
Model 99944200563
MODELS USED ON: | |
| |
| PAS 230/231 |
| PAS 260/261 |
|
WARNING
Read rules for safe operation and instructions carefully. ECHO provides an Operator's Manual with your original Pro Attachment Series power source or Split Boom Trimmer. That manual and this manual must be read and understood for proper and safe operation. Failure to do so can result in serious injury.
X7702093501 | X770001301 |
01/09 |
Assembly
fender / wheel assembly to lower drive shaft assembly
Tools Required: 10 mm Open End Wrench
Parts Required: Lower Drive Shaft Assembly, Fender / Wheel Assembly
1.Remove vinyl cap from lower end of drive shaft tube.
2.Loosen two (2) fender/wheel assembly bracket bolts (A) with 10 mm open end wrench. The bolts should be very loose to prevent bracket from damaging locating arrow decal label.
3.Install fender/wheel assembly, fender side first, onto end of lower drive shaft without serial number label. End of drive shaft should be 95 mm (3.74 in.) from fender clamp. Assure locating hole (B) is facing upward, and locating arrow decal (C) is aligned with edge of fender clamp.
4.Tighten bolts (A).
AA
B
95 mm
C
lower drive shaft assembly to dethatcher gear housing
Tools Required: 4 & 5mm Hex Wrench
Parts Required: Dethatcher Gear Housing, Lower Drive Shaft with Fender / Wheel Assembly
1.Place dethatcher gear housing on a flat surface with gear housing shaft mount at 45° angle.
2.Remove gear housing shaft alignment screw (A) with 4 mm hex wrench.
3.Loosen gear housing shaft mounting bolt (B) with 5 mm hex wrench.
B A
