ProThatch Attachment | 9 |
Operator's Manual |
4.Install and seat lower drive shaft end (end with fender/wheel as- sembly into gear housing shaft mount. Make sure grass guide (D) is facing down toward the ground.
5.Rotate and align hole in drive shaft housing with gear housing shaft hole. Install and tighten alignment screw (A) with 4 mm hex wrench.
6.Tighten gear housing shaft mounting bolt (B) with 5 mm hex wrench.
7.Check for proper inner flex cable (C) engagement into gear hous- ing adaptor. If flex cable extends out of drive shaft then cable is not properly engaged. Rotate and push cable end until lower cable end slides into place in gear housing adaptor. Cable end will recess approximately 16 mm (5/8 in.) into drive shaft.
D
A
B
C
front j-handle assembly
Tools Required: 10 mm Open End Wrench
Parts Required: Pro Attachment Series or Split Boom Upper Shaft and Power Head
1.Remove original front handle assembly. Assemble handle parts with fasteners and store in a safe place for future application with other attachments.
2.Remove two (2)
3.Install
A
A