GRASS TRIMMER

OPERATOR'S MANUAL 11

1.OPERATOR'S MANUAL - Included in plastic bag (co-pack). Read before operation and keep in a safe place for future reference, i.e., operation, maintenance, storage and specifications.

2.SAFETY MANUAL - Included in plastic bag (co-pack). Read before operation and keep in a safe place for future reference to learn proper, safe operating techniques.

3.POWER HEAD - Factory Assembled to the Drive Shaft assembly. Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter.

4.FRONT HANDLE - The Front (loop) handle is factory assembled to the Drive Shaft assembly but must be reposi- tioned for proper cutting attitude and operator comfort.

5.Drive Shaft ASSEMBLY - Factory Assembled to the Power Head. Includes the Rear (right hand) Handle Assembly, Bearing Housing Assembly, Throttle Trigger, Front (loop, left hand) Handle Assembly, Flexible Drive Cable and Safety Decals.

6.NYLON CUTTER HEAD - Contains replaceable nylon trimming line that advances when the trimmer head is tapped against the ground while the head is turning at normal operating speed.

7.DEBRIS SHIELD ASSEMBLY - Included in plastic bag (co-pack). MUST be installed on unit before use, see Assembly Instructions. Shield assembly includes the Cut-Off Knife and Safety Decal. Mounts on the Bearing Housing Assembly just above the cutting attachment. Helps protect the operator by deflecting debris produced during the trimming operation.

8.CUT-OFF KNIFE - Trims line to the correct length (5"). If trimmer is operated without a cut-off knife the line will become too long - more than (5") - the operating speed will slow, the engine overheat and performance will suffer.

9.THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration, press trigger gradually for best operating technique.

10.GRIP - Rear (right hand) handle.

11.STOP SWITCH - "TOGGLE SWITCH" mounted on the engine. Move switch UP to RUN, DOWN to STOP.

12.SHOULDER HARNESS - Optional. An adjustable strap that suspends the unit from the operator.

13.ARM REST - Provides arm rest during operation and protects arm from hot engine.

14.SPARK ARRESTOR - CATALYTIC MUFFLER / MUFFLER -The muffler or catalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing particles of carbon from leaving the muffler. Keep exhaust area clear of flammable debris.

15.FUEL TANK - Contains fuel and fuel filter.

16.RECOIL STARTER HANDLE - Pull handle slowly until recoil starter engages, then quickly and firmly. When engine starts, return handle slowly. DO NOT let handle snap back or damage to unit will occur.

17.FUEL TANK CAP - Cover and seals fuel tank opening.

18.PRIMER BULB - Pumping primer bulb before starting engine draws fresh fuel from the fuel tank priming the carbure- tor for starting. Pump primer bulb until fuel will be visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.

19.AIR CLEANER - Contains replaceable filter element.

20.CHOKE - Located above the air cleaner housing. Move lever to “Cold Start” to close choke for cold starting. Move lever to “Run” ostion to open choke.

21.SPARK PLUG - Provides spark to ignite fuel mixture.

22.SAFETY VIDEO - (Not included with unit) P/N 99922202540 English version only is available at a cost of $5.00 from ECHO, INC. or any authorized ECHO dealer. The video overviews safety precautions and proper operating tech- niques and is supplemental to the Safety Manual. Read and understand the Safety Manual for complete information on safe operation.