GRASS TRIMMER

OPERATOR'S MANUAL 25

4.Hold spool with words "WIND LINE" and tap knob towards you. Place index finger between the two lines and wind line clockwise tightly and evenly.

5.Place ends of line in the two notches (B) molded in the spool with 12.5 cm to 15.2 cm (5 in. to 6 in.) protruding.

6.Place spool in housing against spring (C); thread line ends through housing eyelets (D)

7.Align cover arrow with housing tab; push down on cover and twist clockwise until cover locks in place.

8.Pull both lines out and trim to cut-off knife length.

Before installing, test head. Push center button while pulling on both lines. Trimmer line should advance approximately 1 (one) inch.

D

D

C