GRASS TRIMMER

OPERATOR'S MANUAL 13

ASSEMBLY

Tools Required: Locking Tool (not included). (Use 1/8 in. diameter or less metal bar or small screwdriver.)

PLASTIC SHIELD

1.Snap the shield over the bearing housing.

2.Install bolt (A), washer (B) and wing nut (C).

NYLON LINE HEAD

1.Align locking hole in upper plate with hole in bearing housing.

2.Insert 1/8" dia. locking tool (D) (not included with unit) and remove plastic retaining sleeve. Thread cutting attachment onto PTO shaft clockwise until head is tight.

IMPORTANT

Remember to remove the locking tool.

FRONT (LOOP) HANDLE

NOTE

Front handle is pre-installed. Repositioning and tightening is all that is required.

1.Position front handle (E) in comfortable operating position and tighten wing nut (F). The cutting attachment should be 5cm- 7.5cm (2 in. -3 in.) above the ground and as level as possible.

B

CA

D

E

F