Echo PAS-230 LUBRICATION, Drive Shaft Upper

PRO ATTACHMENT SERIESTM

OPERATOR'S MANUAL 19

NOTE

Every unit is run at the factory and the carburetor is set in compliance with emission regulations. This carburetor does not have acceleration and high speed adjustment needles.

1.Check idle speed and reset if necessary. If a tachometer is avail- able, idle speed screw (A) should be set to the specifications found

on page 22 "Specifications" of this manual. Turn idle screw (A)

clockwise to increase idle speed; counter clockwise to decrease idleA speed.

WARNING DANGER

When carburetor adjustment is completed, the attachment should not rotate at idle, otherwise serious personal injury may result.

LUBRICATION

Level1.

Tools required: 5 mm Hex Wrench, Clean Rag

Parts Required: ECHO® LUBETM 8oz.(P/N91014)orLithiumBase Grease.

Drive Shaft Upper

IMPORTANT

The drive shaft must be lubricated with high temperature automotive grease every 25 hours of operation, otherwise drive shaft assembly overheating and failure can result.

1.Loosen clamping knob (A).

2.Pull locator pin (B) and rotate 1/4 turn counter clockwise to lockout position.

3.Remove attachment.

4.Remove coupler (E) from upper drive shaft assembly by loosening clamping screw (C) and removing set screw (D).

5.Remove upper flex cable (F), wipe clean, and apply a thin coating of 1/2 oz. (15ml) of grease.

6.Install cable. Make sure that the flex cable fully engages into the clutch square drive socket.

7.Slide coupler on upper drive shaft until fully seated, and align set screw hole in coupling with hole in upper drive shaft.

8.Install and tighten set screw (D), and tighten clamping screw (C).