HEDGE CLIPPER 13 OPERATOR'S MANUAL

ASSEMBLY (HCA-2400, SHC-2100,2400)

SHC-1700 is Factory Assembled in the box.

Gear Box/Drive Shaft

(SHC-2100, 2400, HCA-2400)

Tools Required: 8MM Open End Wrench, Screwdriver

Parts Required: Power Head/Drive Shaft Assembly and Gear Box/Blade Assembly.

NOTE

Hedge Clipper Blades are very sharp. Wear gloves to protect hands.

1.Slide the Gear Housing Assembly on the Drive Shaft. Be certain the Flex Drive Shaft engages the hole in Driver Gear.

2.Align the locating screw (A) with the locating hole (B) in the Drive Shaft Housing, tighten screw (A) and clamping screws (C).

Power Head/Drive Shaft (SHC-2400, HCA-2400 Only)

1.Stand engine upright on a level surface.

2.Loosen the two bolts at engine drive shaft end.

3.Carefully fit drive shaft assembly to engine, making sure that inner drive shaft engages into clutch mount.

NOTE

The arrow on the drive shaft housing must be in contact with the engine (arrowon drive shaft indicates line).

4.Rotate the drive shaft housing until arrows are centered with engine bearing housing.

5.Tighten bolts.

Throttle Linkage Installation

1.Close choke and remove air filter cover.

2.Loosen nut (A) and place threaded cable housing in bracket slot. If there are flat washers between the tow nuts, place one on each side of the bracket. Finger tighten nut (A).

3.Place inner cable in slot of carburetor swivel (B) and tighten nut

(A).

4.Check to make sure throttle operates freely, opens completely and returns to idle.

5.Connect ignitions leads (C). HCA-2400 has one spade terminal pair and on ring terminal which attaches under fan cover screw.

6.Re-install air cleaner cover.

SHC-1700, 2100,2400

HCA-2400

A

B

C

A

C