HEDGE CLIPPER 5
OPERATOR'S MANUAL
EQUIPMENT
Before operation a complete check of the unit must be performed;
-Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.
-Inspect fuel lines, tank and area around carburetor for fuel leaks. DO NOT operate unit if leaks are found.
-Inspect hand guard for damage. Replace if damaged or missing.
-Check that the blade assembly is firmly attached and in safe operating condition. Dull, loose or damaged blades should not be used.
-Check that loop (front) handle and shoulder strap/ or shoulder/ waist harness are adjusted for safe, comfortable operation. See Assembly for proper adjustment.
-Tighten the blade angle adjustment lever before operating the
FUEL
WARNING 
DANGER
Fuel is VERYflammable. Use extreme care when mixing, storing or handling or serious personal injury may result.
-Use an approved fuel container.
-DO NOT smoke near fuel.
-DO NOT allow flames or sparks near fuel.
-Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.
-NEVER refuel a unit when the engine is HOT!
-NEVER refuel a unit with the engine running.
-DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks outdoors over bare ground.
After Refueling;
-Wipe any spilled fuel from the unit.
-Move at least 10 ft. (3M) from refueling location before starting.
After Use;
-DO NOT store a unit with fuel in its tank. Leaks can occur. Return unused fuel to an approved fuel storage container.
10' MINIMUM