Echo X750018671, SRM-266 Grass Trimmer/Brush Cutter25 Operators Manual, Nylon line replacement

Grass Trimmer/Brush Cutter25

Operator's Manual

nylon line disassembly instructions

NOTE

For normal use, Speed Feed head disassembly is not necessary. However, if circumstances require disassembly, follow these instructions.

1.Press top of locking tabs (A) on both sides of Speed Feed head to release cover (B) from eyelet carrier(C).

2.Remove cover from eyelet carrier.

C

A

B

nylon line replacement

1.Cut one piece of line to recommended length.

.080 (2.0 mm) dia. – 20’ (6 m)

.095 (2.4 mm) dia. – 20’ (6 m)

2.Align arrows on top of knob with openings in eyelets.

3.Insert one end of trimmer line into an eyelet, and push line equal distance through trimmer head.

4.Hold trimmer head while turning knob clockwise to wind line onto spool until about 5” (13 cm) of each line remains exposed.

Trimmer head is now fully loaded and ready for operation.

IMPORTANT

When the wear indicators located at the bottom of the Speed-Feed head are worn smooth, replacement of the cover or the entire Speed-Feed head is required.

Wear	Wear
Indicators	Indicators