EchoStar MT2 Removing the OTA Module, Unplug the receiver’s power cord from the electrical outlet

REMOVING THE OTA MODULE

Do not remove the OTA Module unless necessary as you will no longer be able to tune to your over-the-air channels if the module is removed.

1.Unplug the receiver’s power cord from the electrical outlet.

2.Disconnect any cables connected to the module’s OVER THE AIR ANTENNA IN port and/or CH 3-4 OUT port.

3.Remove the screws connecting the module to the receiver’s back panel. Gently remove the module.

4.Replace the module port cover and attach it to your receiver using the screws that had connected the module.

5.Plug the receiver’s power cord into the electrical outlet, and turn it back on.

6.Store the OTA Module in the original box when it is not installed in the receiver.

Page 9