EchoStar MT2 manual Removing the Cover

•These instructions assume you have an over-the-air antenna suitable for your area already installed in your system. Refer to www.antennaweb.org or a local retailer for assistance in choosing and peaking an over-the-air antenna.

Installing the MT2 Module

1.Unplug the receiver’s power cord from the electrical outlet.

Unplug the receiver’s power cord from electricity anytime you install or remove the OTA module. Doing so reduces the danger of electrical shock, which could damage the module and the receiver, and injure or kill you.

2.Look at the back panel of your satellite receiver, and locate the cover on the left side of the back panel. Remove the two screws attaching the cover to the receiver (see Figure 1). Keep the screws for use in installing the module.

Figure 1. Removing the Cover

Page 3