EchoStar MT2 manual Connecting to a TV Using the Channel 3-4 Output

6.Select a channel and then select Edit Name to change the way the channel name displays in the Program Guide and other channel lists. You can rename only one channel at a time.

7.Use the on-screen keyboard to enter the channel name.

8.Select Done when you are finished making changes.

Viewing Your OTA Channels

The over-the-air channels that are scanned into the receiver using the previous steps can be viewed in the on-screen Program Guide below channel 100. The OTA channels are listed in yellow in the Program Guide.

Note: You will need to have satellite signal and subscribe to DISH Network programming to view channels received using the OTA Module. Guide information for over-the-air channels displays only if you are subscribed to DISH Network local channels.

CONNECTING TO A TV USING THE CHANNEL 3-4 OUTPUT

Use the CH 3-4 OUT connection to connect to a nearby TV using coax cable. The TV connected to the Channel 3-4 output views the same programming as your TV1 viewing location. Refer to your receiver User’s Guide for more details on the TV1 viewing location.

1.Install the module into the receiver using the instructions on page 3.

2.Connect one end of a coax cable to the CH 3-4 OUT connection of the module.

3.Connect the other end of the coax cable to a coax connection on your TV. This connect may be labeled ANTENNA IN, CABLE IN, or a

Page 7