EchoStar MT2 manual Setting up the Receiver to Display OTA Channels

Setting up the Receiver to Display OTA Channels

1.Using the remote control, press MENU, select System Setup, then Local Channels.

Note: Your Local Channels screen may differ slightly.

Figure 2. Local Channels Screen

2.Scan for channels by selecting Scan Locals.

Note: Ensure the Analog Type on the HDTV Setup menu (accessed by MENU, System Setup, then HDTV Setup) is set to Offair.

3.The scan takes a few minutes to complete. If you want to stop the scan before it is completed, select Cancel. When the scan completes, the results show how many digital over-the-air channels were found.

4.Select OK to go back to the Local Channels screen and view the list of channels.

5.If you want to name the over-the-air channels, follow the steps below. Otherwise, select Done to save the channel list.

Page 6