3Attach the side brackets to the main unit using the supplied flathead screws.
Tip
Be sure to use the supplied accessory mounting screws (Red:M5 x 8) as the mounting screws. If any other screws are used, they may damage the inside of the main unit.
1 Main unit
7Flat head screws
(Red:M5 x 8) x 2
4Side brackets
English
4Mount the stud bolt and bushing to the main unit.
5Insert the main unit into the mounting sleeve until it locks in place.
6Fasten the rear of the main unit.
7Install the bezel on the main unit.
Tip
•Be careful not to forcefully push on the main unit's display or buttons during installation. This may result in damage to the main unit.
•This installation method is only one example. When installing the main unit to the vehicle, be sure to ask the place of purchase for information on the installation method used.
Metal of vehicle
Dashboard or console box
9 Bushing
8 Stud bolt
3 Mounting sleeve
5Bezel
Español Français
- Mounting the main unit (If installing the main unit using the side brackets of the vehicle) -
Tip
•Carefully bind any excess length of wire that is connected to the main unit and secure it to an area of empty space in the vehicle so that it does not dislodge or interfere with the main unit or
•Connect all wires before installing the main unit.
1Remove the pocket and any other accessories from the center cluster to make room for the main unit.
2Remove the mounting brackets for the pocket.
Center cluster panel
Pocket, etc
Mounting bolts
Italiano Nederlands Svenska
- 11 -
