Eicon Networks Diva 2430 manual Windows NT

Setup: TCP/IP Setup Page 28

Windows NT 4.0

The following procedure describes how to install TCP/IP on Windows NT 4.0.

If TCP/IP is already installed on your system, see Configuring TCP/IP (below). Note that if you have more than one adapter installed on your system, you will have to use the adapter that is in use by the Diva 2430.

Procedure

1.Click ‘Start’, ‘Settings’, ‘Control Panel’.

2.Double-click the ‘Network’ icon. The Network dialog box appears.

3.Click the ‘Protocols’ tab.

•If ‘TCP/IP’ is not listed, go to Installing TCP/IP (below).

•If ‘TCP/IP’ is listed, then the protocol is already installed. Go to Configuring TCP/IP (below).

Installing TCP/IP

1.From the ‘Protocols’ tab, click ‘Add’.

2.Select ‘TCP/IP protocol’ as your network protocol, then click ‘OK’.

3.Click ‘Yes’ to use DHCP.

4.When prompted, insert the original Windows NT installation CD and enter d:\i386 (where d: is the drive letter of your CD drive), and click ‘Continue’.

5.Do not click the ‘OK’ button yet; next you will verify your TCP/IP settings. Go to Configuring TCP/IP (below).

Configuring TCP/IP

1.Click the ‘Protocols’ tab.

2.Select ‘TCP/IP protocol’, then click ‘Properties’.

3.Select ‘Obtain an IP address from a DHCP server’.

4.Click the ‘DNS’ tab. Delete any DNS addresses are configured.

5.Click ‘OK’.

6.Restart your computer if requested to do so.