Dialogic® CTbus/SCbus Adapter
Installation
Part Number
Copyright ©
Dialogic Corporation.
All Rights Reserved.
The Dialogic® CTbus/SCbus Adapter is used to interconnect Dialogic® CTbus boards with Dialogic® SCbus boards in the same chassis. Only one adapter is required per system.
Before You Begin
Protect Yourself from Electric Shock
The CTbus carries electrical signals. To reduce the risk of electric shock:
Switch off the power and remove power cords before opening the PC cover.
Do not
Protect the Board from Damage
Protect the Board from Static Electricity
CAUTION: All computer boards are sensitive to electrostatic discharge (“ESD”). Handle all static-
sensitive boards and components at a
If you are not familiar with ESD safety precautions, visit http://www.dialogic.com/support/hwinstall to learn more.
Unpacking the Board
Unpack the Dialogic® CTbus/SCbus Adapter (“adapter”) according to the following steps:
1.Prepare a
2.Carefully remove the adapter from the shipping carton and the
3.Lay the adapter on the
Note: Place the adapter in
CAUTION: Do not remove the adapter from the anti- static packaging until you are ready to install it. Observe proper
Installing the CTbus/SCbus Adapter
Before installing the CTbus/SCbus Adapter, ensure that the Dialogic® boards in your chassis are positioned in the correct order. The board on which the adapter will be installed must be inserted in the first PCI slot adjacent to the ISA slot (Figure 1).
Figure 1. Board OrderTo install the Dialogic® CTbus/SCbus Adapter:
1.Locate the board that will be used to connect the CTbus/SCbus Adapter. It will be the card inserted in the first PCI slot adjacent to the ISA slot.
2.Align pin 1 of the CTbus/SCbus Adapter with pin 1 of the edge connector on the board (Figure 2). NOTE: Edge connector is not labeled.
3.Press the CTbus/SCbus Adapter to the board (Figure 3).
Figure 3. Connect the Adapter4.Connect the CTbus and SCbus cables as per the installation instructions for your Dialogic® board(s).