Eiki EIP-250, EIP-2600 quick start Upper side, Control

4.Adjust the projected image with the Setup Guide

1After the projector turns on, the Setup Guide appears. (When ÒSetup GuideÓ is set to ÒOnÓ. See page 44.)

2Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.

3After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup Guide.

_PP. 26, 27

5. Correct trapezoidal distortion

Correcting trapezoidal distortion using Keystone Correction.

On the projector

Shrinks	Shrinks
upper side.	lower side.

On the remote control

_P. 28

6. Select the INPUT mode

Select the ÒCOMPUTERÓ using INPUT on the projector or COMPUTER on the remote control.

On the	On the remote	INPUT list		On-screen display (RGB)
projector	control	INPUT		COMPUTER
		COMPUTER		RGB
			*	1024 × 768

DDVI-D Computer

D DVI-D Video

*EIP-2600 only

•When you press INPUT on the projector, the INPUT list appears. Press '/" to switch the INPUT mode.

_P. 29

7.Turn the computer on

8.Turn the power off

Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the button again while the confirmation message is displayed to put the projector into standby mode.

On the	On-screen display
	On the remote
projector	control

_P. 25

17