Controlling the Projector by a Computer

When the RS-232C terminal on the projector is connected to a computer with an RS-232C serial control cable (cross type, commercially available), the computer can be used to control the projector and check the status of the projector. Refer to the “SETUP MANUAL” contained on the supplied CD-ROM for “RS-232C Specifications and Commands”.

When connecting to a computer using an RS-232C serial control cable

To RS-232C terminal

Computer

To RS-232C terminal

RS-232C serial control cable (cross type, commercially available)

Note

The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the owner's manual of the computer for details.

Refer to pages 2 to 8 of the “SETUP MANUAL” contained on the supplied CD-ROM for “Connecting Pin Assignments” and “RS-232C Specifi cations and Commands”.

Info

Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This may damage your computer or projector.

Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This may damage your computer.

24