Maintenance Indicators (Continued)
Maintenance indicator | Problem | Cause | Possible Solution | ||
| Normal | Abnormal | |||
|
|
|
| ||
|
|
|
|
|
|
Temperature | Off | Red blinks | The internal | • Temperatures | • Use the projector in an |
warning |
| (On)/ | temperature is | around the projector | area with a temperature of |
indicator |
| Red on | abnormally high. | are high. | lower than 95°F (+35ºC). |
|
| (Standby) |
| • Blocked air intake | • Relocate the projector to |
|
|
|
|
| an area with proper |
|
|
|
|
| ventilation. (See page 8.) |
|
|
|
|
|
|
|
|
|
| • Cooling fan | • Take the projector to your |
|
|
|
| breakdown | nearest EIKI Authorized |
|
|
|
| • Internal circuit failure | Dealer or Service Center |
|
|
|
| • Clogged air intake | for repair. |
Lamp | Green on | Red on | The lamp does | • The lamp is shut | • Disconnect the power cord |
indicator | (Green |
| not illuminate. | down abnormally. | from the AC outlet, and |
| blinks |
|
|
| then connect it again. |
| when the |
|
|
|
|
|
| Time to change | • Remaining lamp life | • Carefully replace the lamp. | |
| lamp is |
| |||
|
| the lamp. | becomes 5% or less. | (See page 55.) | |
| warming |
| |||
| Red on | The lamp does | • | • Take the projector to your | |
| up.) | ||||
| nearest EIKI Authorized | ||||
|
| (Standby) | not illuminate. | • Lamp circuit failure | |
|
| Dealer or Service Center | |||
|
|
|
|
| |
|
|
|
|
| for repair. |
|
|
|
|
| • Please exercise care when |
|
|
|
|
| replacing the lamp. |
|
|
|
|
| • Securely install the cover. |
|
|
|
|
|
|
Power | Red on/ | Green | The power | • The lamp unit cover | • If the power indicator blinks |
indicator | Green on | blinks | indicator blinks in | is open. | in green even when the |
| Red blinks |
| green when the |
| lamp unit cover are |
| (Cooling) |
| projector is on. |
| securely installed, contact |
|
|
|
|
| your nearest EIKI |
|
|
|
|
| Authorized Dealer or |
|
|
|
|
| Service Center for advice. |
Info
•If the temperature warning indicator illuminates, and the projector enters standby mode, follow the possible solutions above and then wait until the projector has cooled down completely before plugging in the power cord and turning the power back on. (At least 10 minutes.)
•If the power is turned off for a brief moment due to power outage or some other cause while using the projector, and the power supply recovers immediately after that, the lamp indicator will illuminate in red and the lamp may not be lit. In this case, unplug the power cord from the AC outlet, replace the power cord in the AC outlet and then turn the power on again.
•The cooling fan keeps the internal temperature of the projector constant and this function is controlled automatically. The sound of the cooling fan may change during operation because the fan speed may change and this is not a malfunction.
54