Press knob on handle. Handle pop out.

PREPARATION

PICTURE LEVEL AND TILT ADJUSTMENT

Picture tilt and projection angle can be adjusted with handles on both sides of a projector. Projection angle can be adjusted to 5.7 degrees upper way.

1

2 Turn handles (right and left) until picture is projected on proper position. Adjust height of rear adjustable feet by rotating them until projector properly stabled on table.

3

Press knob and retract handle.

 

REAR ADJUSTABLE

FEET. (Refer to P7).

LEVEL AND TILT

ADJUST HANDLE

KNOB

ADJUSTABLE

FEET

Height of front feet can be adjusted by turning handles.

MOVING PROJECTOR

For safety, be sure to hold Carrying Handles on both sides by 2 or more people when moving a projector. Moving it unproperly may result in damage of cabinet or person's injury.

Replace lens cover and retract feet to pre- vent damage to lens and cabinet.

CARRYING HANDLE

1

Pull up lock buttons on each side of carrying handles

release locks.

2

Pull carrying handles out fully until it's locked (with a

click). Move a projector by holding two handles by 2 or

 

more people.

3

To retract carrying handles, pull up lock buttons release

lock of handles and press handles fully in until it's

locked.

LOCK BUTTONS

Pull up lock buttons to release lock.

CAUTION IN CARRYING OR TRANSPORTING A PROJECTOR

Do not drop or bump a projector, otherwise damages or malfunctions may result.

When carrying a projector, use a suitable carrying case.

Do not transport a projector by using a courier or transport service in an unsuitable transport case. This may cause damage to a projector. To transport a projector through a courier or transport service, consult your dealer and best case should be applied.

10

Page 10
Image 10
Eiki LC-UXT1 instruction manual Preparation Picture Level and Tilt Adjustment, Moving Projector