5.Turn on the monitor's main power and then switch on the PC's
power.
The indicator lamp, "ON", will light up.
If an image does not appear, refer to the "6. TROUBLESHOOTING" for advice.
Whenever finished, turn off the PC and the monitor.
* When turning on the monitor, the kid of the input signal (Signal1 or 2/Analog or
Digital) is displayed for a few seconds on the right top corner of the screen.
* Adjust brightness of the screen depending on the brightness of your environment.
* Be sure to take adequate rests. A 10-minute rest period each hour is suggested.
When connecting a Power Mac G4 / G5 through ADC (Apple Display Connector),
change the input signal settings of monitor in advance to turn on the Power Mac.
* Be sure that the power switches of both the PC and the monitor are OFF.
1.Open the cable cover and plug the signal cable into the connector
at the rear of the monitor and the other end of the cable into the
video connector on the PC.
After connecting, secure the connection with the screw-in fasteners.
To input the Signal through ADC