The monitor displays the digital input image correctly based on its pre-setting
data.
Analog Input
Screen adjustments for the LCD monitor should be used in suppressing screen
flickering and also for adjusting the screen to its proper position. There is only one
correct position for each display mode. It is also recommended to use the
ScreenManager function when first installing the display or whenever changing the
system. For convenience, an easy set-up program installed on the utility disk to assist
in the set-up procedure is provided.
* Allow the LCD monitor to stabilize for at least 30 minutes before making image
adjustments.
Adjustment Procedure
1.Touch the Auto Adjustment Switch on the control panel.
The message appears and remains on the screen for 5 seconds. While the message is on
the screen, touch the Auto Adjustment switch again to automatically adjust the clock,
phase, screen position and resolution. If you do not wish to do adjust the screen, do not
touch the Auto Adjustment switch again.
* The Auto sizing function is intended for use on the Macintosh and on AT-
compatible PC running Windows. It may not work properly in either of the
following cases.
When running an AT-compatible PC on MS-DOS (Not windows). The
background color for the "wall paper" or "desktop" pattern is set to black.
If the appropriate screen cannot be made by using the Auto Adjustment
switch, adjust the screen through the following procedures. If the appropriate
screen can be made, proceed to step 4.