3 TROUBLESHOOTING

This page presents problems that can be corrected by the user. If a

problem persists even after applying the suggested remedies, contact an E EIZO dealer.

TNo picture

 

 

 

Problems

Points to check with possible solutions

 

 

 

 

 

1)

Indicator status: OFF

Check that the power cord is securely connected.

2)

Indicator status: GREEN

Check brightness and contrast settings. Minimum

 

 

 

 

settings will cause screen to be blank.

3)

Indicator status: YELLOW

Try pressing the power switch. (The Off timer

 

 

 

(flashing)

may be active.)

 

 

 

 

4)

Indicator status: YELLOW

Try pressing a key on the keyboard, or clicking the

 

 

 

 

mouse. (The screen-saver software may be active.)

 

 

 

 

If the problem persists, switch off the monitor

 

 

 

 

main power for a few minutes, then switch it back

 

 

 

 

on and try again.

 

 

 

 

 

5)

“No signal detected” error

Check that the PC is switched ON.

 

 

message appears.

Check that the signal cable is properly connected

 

 

 

 

 

 

 

 

to the graphics board or PC.

 

 

 

 

Check that the graphics board is correctly inserted

 

 

 

 

in the PC.

 

 

 

 

For Windows 95/98/2000 users, install the “Monitor

 

 

 

 

information file” in the utility disk.

 

 

 

 

 

6)

“Out of range” error

Use the graphics board’s utility software to change

 

 

message appears.

the frequency setting. (Refer to the manual of the

 

 

(Example)

graphics board.)

 

 

 

 

 

 

 

For Windows 95 users (OSR 2.0 or newer)/98,

 

 

 

 

restart the PC in a safe mode and change the

 

 

 

 

frequency at the “Display” setting in the PC.

 

 

 

 

 

 

 

 

 

 

•Whenever an error signal message appears, the signal frequency will be displayed in red.

•Error messages will remain on the screen for 30 seconds, and then disappear. An error message may not appear at all if the signal frequency is extremely high or extremely low.

3 TROUBLESHOOTING 29