English
Problems | Points to check with Possible Solutions |
|
|
2. Error messages shown below | These messages appear when the signal is not |
will remain on the screen for 40 inputted correctly, even if the monitor functions properly. | |
seconds. | When the image is displayed correctly after a |
| |
| short time, there is no problem with the monitor. |
| (Some PCs do not output the signal soon after |
| powering on.) |
| Check that the PC is turned ON. |
| Check that the signal cable is properly |
| connected to the PC or graphics board. |
| Switch the signal input by pressing the Input |
| Signal Selection Button on the control panel. |
| If signal inputs from ADC, change the input |
| selection to “ADC” then turn on the computer. |
z The signal frequency is out | Use the graphics board’s utility software to |
of range. Error signal | change the frequency setting. (Refer to the |
frequency will be displayed | manual of the graphics board.) |
in red. |
|
(Example) |
|
3. Display position is incorrect. | Adjust the image position using the <Position> | |||
|
|
|
| (p. 29) If the problem persists, use the graphics |
|
|
|
| board’s utility software to change the display |
|
|
|
| |
|
|
|
| |
|
|
|
| position if available. |
|
|
|
|
|
4. Screen image is smaller or larger | Adjust the resolution using the <Resolution>. |
than the actual screen images. | (p. 30) |
5.Vertical bars of distortion appear. Decrease the vertical bars using the <Clock>.
(p. 28)
42 7. TROUBLESHOOTING