English

The Priority Input Signal

This function is used to select which PC will have priority to control the monitor when utilizing two PCs. The monitor constantly checks the input signals and switches automatically in accordance with the “Input Priority” setting (see table below). Once a priority is set, whenever a change of signal is detected at the selected input, the monitor will switch the input to that signal.

In the case of only one signal being present at either input, the monitor automatically detects and displays that signal.

Priority Setting

Performance

 

If signals from both inputs are present, the monitor gives preference

1

to Signal 1 in the following cases.

• When the power of the monitor is turned ON

(SIGNAL 1 – DVI-I

Input Connector)

• When the signal input to Signal 1 is changed even if active input

 

was Signal 2.

 

 

2

If signals from both inputs are present, the monitor gives preference

to Signal 2 in the following cases.

(SIGNAL 2 – D-Sub

• When the power of the monitor is turned ON

mini 15 pin Input

• When the signal input to Signal 2 is changed even if active input

Connector)

 

was Signal 1.

 

The monitor will not detect signals automatically in this mode. Select

Manual

the active input by pressing the Input Signal Selection Button on the

 

monitor’s control panel.

NOTE

•When the “1” or “2” is selected, the power saving mode of the monitor activates only if both PCs are in power saving mode.

20 2. CABLE CONNECTION