Start with the bottom scope. Hold it in one hand, and put the next scope on top of the 1st, the same way around. Align the stacking connectors and when the stacking connectors are partly mated engage the front “P” shaped clip (BNC end) on the 2nd scope into the “P” shaped slot on the 1st scope.
Now, bring the back edge “P” clip (USB end) of the 2nd scope down until it clicks into the 1st scope’s slot. These two scopes are now mated.
Check that as you pushed the 2nd scope down, the stack connector has not been forced upward…if it has simply press it down until it seats correctly (see picture above for a guide as to the normal exposed connector depth after stacking). Repeat this for each remaining scope, adding each one on top of the previous one.
The scopes are now stacked.
2.3.2 Disassembling The Stack
Start with the top scope in the stack. Grasp the stack in one hand and with the other hand’s thumb and forefinger, pinch between the interface between the top two scopes, near the back “P” clip (USB end). With moderate force, the top scope will pop up and come free. Remove the stacking connector from the free scope.
Repeat this for all scopes in the stack.
Elan Digital Systems Ltd. | 10 | USBscope50 USER’S GUIDE Iss5 |
