Design Beam 300™
©Elation Professional, Los Angeles Ca. 42 www.ElationLighting.com
seconds. The red/green LED indicators on the transmitter and the fixture should
then begin to flash rapidly for about 5~ 10 seconds while the two system pair
c) Once the fixture is paired with the transmitter (T1), the WDMX status indicators
on the both the fixture and the transmitter will stop flashing and glow solid green.
If the paring is unsuccessful repeat the process until the paring is secured.
d) The fixture will store the pairing information inside a nondestructive memory
bank once a link is created between the fixture and a transmitter. The fixture will
remember the paired transmitter even if the fixture is turned off for extended
periods of time.
12.3 Clearing Transmitter Link:
1) Access the fixture’s main menu and toggle to Personality - Wireless DMX – Reset.
Select “Reset” to clear any existing link between the fixture and a transmitter. The
WDMX indictor on the fixture will turn solid red when the link is severed.
2) You may also clear the link from the transmitter. First, be sure the fixture(s) is
powered on, and then hold down the configuration button on the transmitter for as
least 5 seconds. This will automatically clear the link between the transmitter and
any fixture that is powered on. All WDMX indictors will glow solid red if the procedure
was successful.
12.4 WDMX Indicators:
1) Rapid flashing Red/Green: Syncing in to a transmitter.
2) Slow flashing Red/Green: Paired with a transmitter. Transmitter is not receiving a
DMX signal from a controller.
3) Solid Green: Paired with a transmitter and receiving DMX data.
4) Solid Red: Not paired with a transmitter (free)