Design LED 60 TriStrip™
to the digital control information sent out from the DMX controller. The allocation of this starting DMX address is achieved by setting the correct DMX address on the digital display located on the head of the fixture.
You can set the same starting address for all fixtures or a group of fixtures, or set different address for each individual fixture. Be advised that setting all you fixtures to the same DMX address will subsequently control all fixtures in the same fashion, in other words, changing the settings of one channel will affect all the fixtures simultaneously.
If you set each fixture to a different DMX address, each unit will start to “listen” to the channel number you have set, based on the quantity of control channels (DMX channels) of each fixture. That means changing the settings of one channel will only affect the selected fixture.
In the case of the Design LED 60 TriStrip™, which is up to a 63 channel fixture (maximum DMX channels), you should set the starting DMX address of the first unit to 1, the second unit to 64 (63 + 1), the third unit to 127 (63 + 64), and so on.
Note: During
If your fixture is connected to a DMX controller and the display is flashing (not receiving a DMX signal), please check the following:
-The
-The DMX controller is switched off or defective.
-The DMX cable or connector is defective.
-A DMX terminator has been inserted into the last fixture in your DMX chain.
©Elation Professional, Los Angeles Ca. | 17 | www.ElationLighting.com |
