Electrolux 241721800 manual PureSource TM Ice and Water Filter some models

Models: 241721800

1 25
Download 25 pages 4.28 Kb
Page 16
Image 16
16
• Rated Capacity - 1514 liters
• Rated service flow - 1.9 liters per minute
• Maximum Rated Pressure - 6.9 bars
• Maximum Operating Temp. - 37.8° C
IMPORTANT: ResettingThe Filter Status Light (some models)
After replacing the filter cartridge, it will be necessary to press the Filter Status reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.
On models without a Filter Status reset button, there is a set of Reminder Stickers included in the envelope that the Use & Care Manual came in. Choose a dated sticker that indicates 6 - 9 months (depending on your water quality and usage) from the date of installation. Place the sticker on the front of the filter cup to remind you when it is time to change the filter.
Order new filter cartridges through the dealer where you bought the refrigerator or contact the Electrolux Customer Care Center . It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the RG- 100 PureSource™ replacement cartridge.
The PureSource™ NGRG-
2000 Ice and Water Filter System with the RG-100 cartridge is tested and certified by NSF International,
the nationally recognized and respected, not for profit, certification organization for public health safety. The PureSource™ system is tested and certified to ANSI/NSF Standard 42. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.
Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after 400 gallons of water has flowed through the ice and water dispenser (some models). Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed).
To change filter:
It is not necessary to turn the water supply off to change the filter.
1. Open freezer door and leave open until filter change is complete.
2. Turn the ice maker’s power switch to the Off (“O”) position (See illustration on page 14).
3. Hold filter cup firmly, and unscrew towards left (Some water could
leak out as you remove cup. This is normal.). Filter cartridge should come down with cup. If cartridge remains in housing, pull down gently, while twisting filter back and forth.
4. Rinse out cup under running water.
5. The large o-ring that seals the filter system sets in the o-ring groove down inside the cup. Should the o-ring fall out during filter cartridge replacement, simply place it back in the groove prior to screwing the cup back in place. If the o-ring becomes damaged, you will need to order one from the Customer Care Center.
6. Discard old filter cartridge.
7. Remove new filter cartridge from packaging and place in cup. The end with the small o-ring should be up, out of the cup.
8. Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall Cup. Filter cartridge will self-align as cup is tightened. Be sure cup is completely tightened with PureSource™ logo facing outward. Do Not
Tighten Past Stop.
9. Turn the ice maker’s power switch to the On (“I”) position.
10. Check for leaks. Open refrigerator door. Wipe any water droplets from the filter cup. Fill a glass with water. If there is a leak, unscrew filter cup, and reinsert the filter cartridge. Check placement of large O-ring. Reinstall filter cup, making certain it is tightened completely.
11. To condition filter system and purge air from water line, fill a glass with water. Continue flushing the system for approximately 3 minutes to assure that the purest water possible is stored in the water tank.
NOTE: If you purchased a refrigerator with a PureSource TM Ice and Water filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right back corner of the fresh food compartment.
System Startup:
Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section
to properly fill the system with water. Changing the Filter:

Automatic Ice and Water Dispenser

PureSource TM Ice and Water Filter (some models)

Page 16
Image 16
Electrolux 241721800 manual PureSource TM Ice and Water Filter some models

241721800 specifications

The Electrolux 241721800 is a high-performance refrigerator that stands out in the market due to its innovative features, energy efficiency, and sleek design. This model has garnered attention for its advanced technologies, which not only enhance food preservation but also ensure optimal user convenience.

One of the defining features of the Electrolux 241721800 is its advanced cooling system. This refrigerator employs an efficient dual cooling technology that separates the airflow between the refrigerator and freezer compartments. This not only prevents the mixing of odors but also maintains the ideal humidity levels in both areas, ensuring that fruits and vegetables remain fresh for longer.

Another notable characteristic of the Electrolux 241721800 is its Energy Star certification. This appliance is designed to be energy-efficient, consuming significantly less electricity compared to traditional refrigerators. By adhering to strict energy guidelines, it helps users save on utility bills while reducing their carbon footprint.

The interior of the refrigerator is designed with user convenience in mind. It features adjustable glass shelves that allow for customizable storage options, accommodating items of various sizes. The LED lighting provides bright and clear illumination, making it easy to find your groceries even in the darkest corners.

In addition to storage versatility, the Electrolux 241721800 includes a water and ice dispenser conveniently located on the front door. This feature not only eliminates the need to open the refrigerator frequently but also offers instant access to cold water and ice, enhancing the overall user experience.

For added convenience, the appliance is equipped with a digital temperature control system. This allows users to monitor and adjust the temperature settings with ease, ensuring food safety and optimal preservation. The external digital display provides a straightforward interface, making it easy to operate even for those who may not be technologically savvy.

Overall, the Electrolux 241721800 stands out as a reliable and feature-rich refrigerator that combines advanced technology with practical design. Its cooling performance, energy efficiency, and user-friendly features position it as an excellent choice for modern kitchens, catering to a variety of family needs while maintaining the freshness of your food.