Removing the Doors | Electrolux 241978401 manual

10Removing the Doors

Getting through narrow spaces

If your refrigerator will not fit through an entrance area, you can remove the doors. Check first by measuring the entrance.

To prepare for removing the doors:

1Make sure the electrical power cord is unplugged from the wall outlet.

2Open the freezer drawer and remove the toe grille (see “Installation” section).

3Remove any food from the door shelves and close the doors.

To remove the top hinge covers:

1Remove the two (2) screws from each cover over the top door hinges.

2Lift inside edge of hinge cover and tilt back.

To remove the refrigerator doors:

1Trace lightly around the door’s top hinges with a pencil. This makes reinstallation easier.

2Disconnect the harness by grasping both sides of the connector firmly, depress the latch, and pull apart. Remove the two (2) screws from the top hinge. Lift the door off of the bottom hinge and set it aside.

NOTE

3Detach the water tube from the connector located behind the refrigerator and pull the tube back out to the front of the unit. The connector releases when you press inward on the outer sleeve while pushing the tube toward the connector then while continuing to hold in the sleeve, pull the tube away.

DO NOT remove the ground screw from hinge.

Image 10

Electrolux 241978401 manual Removing the Doors, Getting through narrow spaces, To prepare for removing the doors

Contents

Use & Care Guide Finding Information Safety Precautions SafetyImportant safety instructions Definitions Electrical information Feature Overview Understanding features and terms Location InstallationInstallation Door opening To level the cabinet using the front rollers select Models To adjust the door stop To adjust the flipper mullion To prepare for removing the doors Removing the DoorsGetting through narrow spaces To remove the top hinge covers Lower Hinge Removal Connecting the Water Supply To Avoid Property Damage Controls 1st Level Sleep Mode2nd Level Awakened Display Mode Wave-TouchTM Alarms Setting cooling temperatures3rd Level User Variable Options Wave-TouchTMSabbath Mode Sabbath Mode and the Custom TempTM Drawer Priming the water supply system Using the ice maker after installationAutomatic Ice & Water Maker/Dispenser Ice maker operation & care Cleaning the ice maker Ice maker/dispenser tips Drawers Storage FeaturesShelf features Crispers Deli keeper select models To remove the Crisper Drawer for cleaningSpecial items rack select models Custom TempTM Drawer select models Storage bins To change the position of an adjustable door binDoors Tall bottle retainer Dairy compartment Freezer Features varies by modelTilt Wire Shelf To Remove Upper and Middle Baskets Dividers Removal Ideas for storing foods Storing Food and Saving EnergyIdeas for saving energy Normal Operating Sounds Understanding the sounds you may hear About your advanced water filter Changing The Water and Air FiltersWater filter Replacing your PureAdvantageTM water filter Air filter Ordering replacement filtersReplacing your PureAdvantageTM air filter Care and Cleaning Protecting your investment Vacation and moving tips Care and cleaning tipsPart Cleaning Agents Tips and Precautions Occasion Tips Replacing Light Bulbs select models Ordering Replacement LED LightsReplacing LED Lights select models To replace LED Lights Problem Cause Correction Solutions to Common ProblemsBefore you call Light Is Not On Temperatures Are Too Cold Water Dispenser Warranty Consumer