LOCATION OF APPLIANCE

This appliance must not be installed in a bed-sitting room of volume less than 20m³ or in a bathroom or
shower room. It is essential that the appliance is positioned as stated below. The appliance must be a
minimum of 20mm from the rear wall (note that this dimension is provided by the inlet elbow). Shelves, wall
cabinets and cooker hoods must not be fitted closer that 500mm to the top of the grill canopy or within 100mm
of the sides of the grill. Curtains must not be fitted immediately behind the appliance or within 200mm of the
sides of the grill. If fitted next to or between two base units a minimum space of 1mm must be left between
the units and the sides of the appliance. The hotplate must be set to a minimum of 7mm above the adjacent
units (note that the levelling feet fitted to the appliance will achieve a nominal height to hotplate level of
907mm -5+13mm). Base units not meeting the above conditions must be a minimum of 100mm away from the
hotplate.
L.P.G. cookers MUST NOT be installed below ground level, i.e. in a basement, or aboard any boat, yacht or
other vessel.
INSTALLATION

1. PARTS REQUIRED

The loose hotplate parts are packed in the polystyrene fitment on the top of
the hotplate. The grill pan, grill pan handle, fixing screws and splashplate
fixing screws can be found in the furniture pack which is located in the
bottom compartment. The grill pan requires assembly before use (see Fig.
1).
NOTE: Taptite screws are used to secure the handle. These are
thread forming screws and sufficient pressure must be applied to
allow the screws to produce a thread in the plunged holes.

2. GRILL ASSEMBLY

The two splashplate screws marked A (see Fig 1a) should be screwed into
the back of the appliance about halfway in. Engage the keyhole slots in
the splashback behind the two screws taking care not to trap the H.T. wire
(see Fig. 1b).
Insert the four splashplate screws marked B (see Fig. 1b).
Tighten 6 off splashplate screws. (see Fig. 1b).
Connect the grill supply union at the back of the appliance and pull the grill
H.T. lead through the opening in the splashplate. Feed lead through the
hole in the top right hand side of the splashplate and connect on to the grill
electrode, (see Fig. 1b).
R E N O W N D E L U X E
Grill Pan Handle Assembly:
Assemble grill pan (see Fig.1)
and secure two screws
provided.
Fig.1
Fig.1b
Fig.1a
33
Connect grill H.T. lead
to grill electrode